FOREVER KW-50 Mode D'emploi page 11

tion. The watch only answers the calls from numbers that were
GB
previously set in the application contacts.
The application does not update location in real-time. It se-
lects LBS locations only
Reason: GPS signal is too weak to locate the watch or the watch
is in sleep mode.
Solution: – Leave the building with the watch and press the "LO-
CATION" function in the "MAP" function.
– Remember that the application allows to set appropriate
watch operation mode. This is associated with the frequency of
collecting data, also those related to the location. In the energy-
saving mode, data is send once every hour. Therefore, to main-
tain full control of the location in real-time, it is recommended
to use normal mode, which collects data every 10 minutes, or
tracking mode, in which data is collected every minute.
The watch does not display current time and date
Reason: The watch failed to connect with the application server
in order to update time.
Solution: – Time may also be updated in connection with GPS
location. It may be checked by going outside and using GPS lo-
calizer function.
– If the watch is several hours behind, check and select ap-
propriate time zone via the application.
– If the aforementioned activities will not solve the problem,
send the following SMS from your phone (to the number
of the SIM card installed in the watch): pw,123456,ntp-
servers,121.40.88.40,8089#
The watch should respond with an SMS with similar contents.
Then, restart the watch. Additionally, you may also send a
11