Beta 1838AM Notice D'utilisation Et Instructions page 5

OPERATION MANUAL AND INSTRUCTIONS
OPERATION MANUAL AND INSTRUCTIONS FOR 2-LED SWIVEL LAMP MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE LAMP.
FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND OPERATING
PROCEDURES MAY RESULT IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The lamp can be used for the following purpose:
• lighting workplaces
The lamp must not be used for the following operations:
• must not come into contact with chemical and corrosive substances
• must not be used for any applications other than recommended ones
WORK AREA SAFETY
Do not operate the lamp in environments containing potentially explosive atmospheres, because sparks may be
generated, which can ignite the dust or fumes.
Do not use the lamp near flammable material.
LED LAMP SAFETY
- Before use, check that the lamp has not been damaged, and that no parts are worn.
- Do not force the electronic circuit of the lamp. Do not modify the lamp. This can reduce the effectiveness of safety
measures and increase operator risk.
- The LED light source cannot be replaced; if it is either damaged or at the end of its life cycle, replace the entire lamp.
- To clean the lamp, use a dry cloth and always disconnect the mains power supply from the lamp.
PERSONNEL SAFETY INSTRUCTIONS
- Stay alert; watch what you are doing.
- Do not direct the LED light beam at people or animals: this may cause temporary blinding.
BATTERY USE AND CARE
- When using the lamp for the first time, charge the battery for 3-4 hours.
- Check that the power supply cable is in good condition.
- Fully charge the lamp when not using it for a long time.
- Do not charge the lamp in humid or wet environments; do not expose it to the weather.
2-LED SWIVEL LAMP
EN
5