tiko Energy Solutions Bridge-Box Athos Mode D'emploi page 4

Bridge-Box User's Manual
Intended Use
The Bridge is a power supply and communication interface for other tiko devices and only
to be used in tiko Energy Solutions AG authorized setups.
The Bridge presents on both sides an SBUS connector (IMAGE 1) to be daisy-chained
with other devices of the same family.
Any installation or usage which does not conform to tiko Energy Solutions AG setup is
strictly forbidden. tiko Energy Solutions AG is not responsible for any improper installa-
tion/usage of this device.
Features
Bridge features:
•
power supply unit (PSU) for SBUS devices to source ca. 10 W @ 5 VDC with
short-circuit and overload protection
• independent short-circuit / overload protection on the SBUS to keep the Bridge
powered even in case of short-circuit on the SBUS
• GreenPHY PLC bridge between SBUS devices and gateway (M-Box)
• Status LEDs showing data link and device errors
•
Button to hard reset the device
Package Content
Open the package and check that you have all the following items:
• Instruction manual
•
Bridge
•
50 cm SBUS interconnection cable or SBUS inter-connector (IMAGE 2)
• Clip A and Covers B and C (IMAGE 3)
If any of the parts are incorrect, missing, or damaged, please contact the retailer where
you made your purchase. Keep the carton box, including the original packing materials, in
case you need to return the unit for repair.
Device
IMAGE 4 shows the device from front and top view. It indicates the LEDs, the button,
and the clamping terminals for Line In ❶, Neutral In ❷. On the left side are two labels
indicating
•
The manufacturer
• The device model number (REF) and the current rating
•
The hardware (HW) and firmware (FW) version
•
The unique serial/MAC address as text and as Aztec 2D code (SN/MAC)
tiko Energy Solutions AG
English
Overview
4 / 48
IM-0007-0002 Rev. 7