Bimar VR29 Notice D'instructions page 15

 " " button: cools the air and evaporates micro-particles of H²O it is filled
with: this function is most effective in drier air, and is less effective as relative
humidity increases (RH). The button starts and stops the water pump. If the
water level is below the minimum level, the "COOL" indicator light flashes
quickly and the pump will stop working after about one minute.
 " " button operates the three speeds, the symbol corresponding to the
selected speed lights up: (LOW=min; MID=med; HIGH=max).
 " " button, see above.
 " ", button timer: sets the time of operation, after which the unit will stop.
Repeatedly press the button: each press changes the time (from 0,5 hour to
7,5 hours), the selected time will light up on the control panel. To deactivate
the timer, press the button until the display time disappears.
 " ": produces a flow of negative ions which neutralise positive ions in
the air, the corresponding symbol lights up when it is active.
USE
To start the appliance, plug it into the mains, press the "
the required functions. To turn the unit off completely, after pressing the "
button, remove the plug from the plug point.
If the appliance is not being used for long periods of time, remove the plug from
15/44
" button and choose
"