PROLUMIA ROCKDISC II Manuel D'utilisation page 6

MOUNTING
1. Disassemble the diffuser with the supplied Allen key and open the fixture.
2. Open the LED panel.
3. Pull the power cord through the gasket.
4. Fix the fixture on the surface with screws.
(Pay attention to the direction. This is indicated by the "UP" marking on the base of the fixture.)
5. Connect the power cord on the terminal correctly and fix it with the strain relief. (Caution: Earth cable must be connected firmly.)
6. Close the LED panel.
7. Assemble the diffuser.
Rubber
Metal
Min. 18mm
5 Cable connection
MAINS POWER SUPPLY
6
PH2
ø6mm
www.prolumia.com
Min. 45mm
40mm
Pay attention:
• With stone, do not drill into the
joint/edge of the stone
• Do not use a pneumatic hammer
drill in soft stone
• Clear the borehole from dust