Troubleshooting - Kobalt KST 2580-06 Mode D'emploi

CARE AND MAINTENANCE
4. Inspect
adequate amount of line and that no damage is present
to the

TROUBLESHOOTING

If you still have questions or an unresolved issue after going through this troubleshooting guide, or
just want to speak to a Kobalt product expert, please call our customer service department at
1-888-3KOBALT (1-888-356-2258), 8 a.m. - 8 p.m., EST, Monday – Sunday.
PROBLEM
Motor fails to start
when switch trigger
is depressed.
Trimmer smokes
during operation.
Trimmer head will
not advance line.
Line is not cutting
well.
and line to ensure that there is an
.
POSSIBLE CAUSE
1. Battery is not secure.
2. Battery is not charged.
3. Possible wiring or electrical contact
problem.
1. Trimmer damaged.
1. The motor shaft or trimmer head is
bound with grass.
2. Not enough line in the spool.
3. Trimmer head is dirty.
4. Line is tangled on the spool.
1. The cutting blade on the guard has
become dull.
4
CORRECTIVE ACTION
1. To secure the battery, make sure
the latches on the battery compart-
ment snap into place.
2. Charge the battery according to
the instructions included with your
model.
3. Call 1-888-3KOBALT (1-888-356-
2258) for technical service.
1. Do not use the string trimmer.
1. Stop the trimmer, remove the
battery, and remove any grass.
2. Remove the battery and replace
the trimmer line. Reference section
"Cutting Line" in this manual.
3. Remove the battery and clean the
spool.
4. Remove the battery, remove the
line from the spool and rewind.
1. Sharpen the cutting blade with a
file or replace it with a new blade.
19