KENMORE ELITE KKEB1.3HSS Guide D'utilisation Et D'entretien page 4

OPERATING YOUR BLENDER
ICE CRUSH
Press the On/O and then the Ice Crush button. the Blender will spin for one second and rest for
two seconds. This will repeat 5 times. The blender will then run continuously for 45 seconds and
then turn o . See CRUSHING ICE in BLENDER TIPS AND TECHNIQUES section for further ice crush-
ing details.
PULSE MODE
The blender has a Pulse function that is controlled by pressing one of the other function buttons
after the Pulse button has been pressed. To run the blender intermittently (pulse mode) rather
than continuously, rst press the PULSE button. The PULSE button words will illuminate. P will
ash in the display window. Now select, press and hold the Stir, Chop, Mix or Liquefy button.
When you release the button the blender will stop and turn o . Press the Pulse button again if you
want to leave Pulse operation.
MEASURING CUP LID HOLE
To add food or pour liquid into the jar while blender is
in operation, remove the measuring cup in the middle
of the lid.
Add the ingredients through the hole in the middle of
the lid, and then replace the measuring cup
After adding ingredients, DO NOT allow the blender to
run without the lid and measuring cup securely in
place. The speed of the blades will throw contents high
up in the jar, and without the lid could spill out.
WARNING
Do not touch blades. Always turn blender o and wait until
blades have stopped rotating before removing jar or lid.
CAUTION - When removing jar from motor base after recent blender
operation, avoid contact with the metal gear on the underside of
the blade assembly. The gear will be hot from use.
6
OPERATING YOUR BLENDER
USING THE SINGLE SERVE CUP
1. Insert the appliance plug into an appropriate wall
socket.
2. Fill the single serve cup with desired food and
secure the blade assembly lid onto the cup as shown.
See Fig. 6.
3. Turn the single serve cup upside down and place it
onto the motor base, aligning the tabs on the cup
with the motor base. Press the On/O button. The
Single Serve button words will ash 3 times and then
go out. The On/O button words and the timer in the
window display will begin ashing.
4. Press the Single Serve button to start blending. The
Fig. 5
timer in the window display will count the number of
seconds each time the Single Serve button is pressed.
Operate blender with Single Serve button until
ingredients are satisfactorily blended. Press On/O
button to leave Single Serve function.
5. Rotate the single serve cup counterclockwise and
take it out from the motor base. See Fig. 7.
6. Turn the single serve cup over and rest it on a at
surface. Replace the blade assembly with the drinking
lid. See Fig. 8.
Raise the cap on the drinking lid to drink the blended
contents directly out of the cup.
Fig. 6
Fig. 7
Fig. 8
7