Publicité
Les langues disponibles
Les langues disponibles
PREPARING YOUR BLENDER
1. Before assembling your blender, wipe blender base with a warm sudsy cloth, then wipe clean
with a damp cloth. Dry with a soft cloth. Wash blender jar, lid, and blades in warm, sudsy water.
Rinse and wipe parts dry.
CAUTION - NEVER place blender motor base in water or other liquid.
CAUTION - Blades are sharp. Handle carefully
2. Align the guide ribs inside the jar collar with the
guide grooves on the motor base and lower the jar
securely into place (Fig. 2).
WARNING - Injury Hazard
Unplug mixer before touching
beaters or other accessories.
Failure to do so, can result in
broken bones, cuts or bruises.
CONTROL PANEL
Your blender has been designed to work in a variety
of ways to suit your blending needs. You can easily
control its blending function by means of the control
panel buttons: Single Serve, Stir, Chop, Mix, Liquefy,
Ice Crush and Pulse Single Serve and Pulse allow
intermittent operation. Stir, Chop, Mix and Liquefy are
continuous operation in an ascending scale of speed
from Stir (slowest) to Liquefy (fastest). Ice Crush
contains a programmed series oof short operation
bursts and pauses followed by a continuous blending
period. See Fig. 3.
Fig. 3
Fig. 2
guide
groove
4
OPERATING YOUR BLENDER
TO OPERATE BLENDER
1. Place Blender motor base on a dry, level, stable surface.
2 . Set jar assembly into place on motor base.
3. Place the food solids and liquids to be blended into the jar and put the lid on the jar before
blending. Secure the lid onto the jar by snapping the Lid Lock Flaps over the tabs on the side of
the jar. See Fig. 4. Be sure the measuring cup is in place in the middle of the lid.
NOTE - For easy lid removal, hold hand over Lock Flap on one side of lid. With other hand, release
Lock Flap on other side of lid and lift lid up.
4. Plug power cord into a standard 120-V, 60 Hz AC-only, 3-prong electrical outlet. Press the
On/O button to turn on the blender controls. The blue LED will ash 0:00 for the timer, and the
On/O button words will ash.
IMPORTANT - Always rest one hand on top of blender jar with lid securely in place when operat-
ing blender.
Fig. 4
BLENDER FUNCTIONS
When a function button is pressed, the function operates continuously (except Ice Crush) at one
speed for a 1 minute cycle and then stops. Press the button again to turn the function o prior to
1 minute. To reactivate the function past the 1 minute cycle, simply repress the button.
NOTE - Once the On/O button is pressed, the button and window display will go out if no
function button is pressed within 2 minutes.
SINGLE SERVE
Use SINGLE SERVE function only when the Single Serve Cup is inserted onto the motor base. See
USING THE SINGLE SERVE CUP section in this Use & Care Guide.
STIR, CHOP, MIX or LIQUEFY
Press the On/O button. The button words will ash and timer will ash 0:00 in window. Press Stir,
Chop, Mix or Liquefy function button to start blender blade rotation. Timer will count up to 1
minute and blender will stop. Press On/O or function button at any time during cycle to cancel
operation.
5
Publicité
