Medtronic Guardian Sensor Manuel D'utilisation page 9

4
5
6
7
4. Open the sensor package.
5. Hold the pedestal and remove the
glucose sensor assembly from the
package. Place the pedestal on a
flat surface.
Note: The pedestal and glucose
sensor assembly are the established
definitions in the component table.
6. Make sure that the
7. Holding serter
- 7 -
adhesive tab of the
sensor is tucked
under the sensor
connector and sensor
snaps.
correctly
Place your thumb
on the thumbprint
marking to hold
the serter without
touching the buttons.
Holding serter
incorrectly
Your fingers should
not be touching the
buttons.