Medtronic Guardian Sensor Manuel D'utilisation page 5

are sterile and non-pyrogenic, unless the package has been
opened or damaged. Do not use the sensor if the sterile package
has been opened or damaged. Use of an unsterile sensor can
cause site infection.
This product contains small parts and may pose a choking hazard
for children.
Watch for bleeding at the insertion site (under, around, or on top of
the sensor).
If bleeding occurs, do the following:
1. Apply steady pressure, using sterile gauze or a clean cloth
placed on top of the sensor, for up to three minutes. The use of
unsterile gauze can cause site infection.
2. If bleeding stops, connect the transmitter (or recorder) to the
sensor.
If bleeding does not stop, do not connect the transmitter to the
sensor because blood can get into the transmitter connector,
and could damage the device.
If bleeding continues, causes excessive
pain or discomfort, or is significantly visible
in the plastic base of the sensor, do the
following:
1. Remove the sensor and continue to apply
steady pressure until the bleeding stops.
Discard the sensor in a sharps container.
2. Check the site for redness, bleeding, irritation, pain,
tenderness, or inflammation. Treat based on instructions from
your healthcare professional.
3. Insert a new sensor in a different location.
General precautions
Wash your hands with soap and water before inserting the sensor
to help prevent site infection.
Wear gloves when inserting the sensor into someone other than
yourself to avoid contact with patient blood.
Do not insert the sensor through tape. Inserting the sensor through
tape may cause improper sensor insertion and function.
Only use alcohol to prepare the insertion site, to ensure that
residue is not left on the skin.
Rotate the sensor insertion site so that sites do not become
overused.
- 3 -
plastic base