Battery-Powered Telescopic Handle; Safety Instructions - Gartenmeister AAS 4025 Mode D'emploi

2.

Battery-powered telescopic handle

Safety instructions

Attention! Read all instructions contained here-
in. Failure to observe the following instructions
may result in electric shock, burns and/or severe
injury. The term 'power tool' used in the follow-
ing includes both mains-operated tools (with
mains supply) and battery-operated tools (with-
out mains supply).
KEEP THESE INSTRUCTIONS CAREFULLY!
1) Safety at the workplace
a) Keep your working area clean, tidy and
well-lit. Disorder and poorly lit working areas
may result in accidents.
b) Do not operate the power tool in poten-
tially explosive environments containing
combustible fluids, gases or dusts. Power
tools generate sparks that may ignite dusts
or fumes.
c) Keep children and other persons away
while you are operating the power tool.
Distractions may result in the operator loosing
control over the tool.
2) Electrical safety
a) The mains plug of the power tool must fit
into the mains socket. The plug must not
be modified in any way. Do not use adapt-
er plugs/connectors in combination with
tools with protective earthing. Unmodified
plugs and fitting sockets reduce the risk of
electric shock.
b) Avoid physical contact with earthed sur-
faces as pipes, heaters, ovens and refrig-
erators. There is an increased risk of electric
shock if your body is earthed.
c) Keep the tool out of the rain or moisture in
general. The penetration of water into a pow-
er tool increases the risk of electric shock.
d) Do not use the cord to carry or hang up
the tool or to pull the plug out of the sock-
et. Keep the cord away from heat, oil and
sharp edges or moving parts of the tool.
Damaged or tangled cords increase the risk
of electric shock.
e) When operating a power tool outdoors,
use exclusively extension cords that are
GB | Operating Instructions
f) If the operation of a power tool in a moist
3) Personal safety
a) Always pay attention to what you do and
b) Wear personal protection equipment and
c) Avoid unintentional operation. Make sure
d) Remove adjustment tools or wrenches
e) Avoid unusual postures. Make sure to
f) Wear suitable clothes. Do not wear wide
g) If dust extraction/collection devices are
12
approved for outdoor-use. The use of an
extension cord that is suitable for outdoor use
reduces the risk of electric shock.
environment cannot be avoided it is highly
recommended to use a residual current
device (RCD). The use of an RCD reduces
the risk of electric shock.
apply reasonable care when working with
a power tool. Do not use the power tool
when you are tired or under the influence
of medication, drugs or alcohol. When
working with power tools, even a short mo-
ment of inattentiveness may result in severe
injury.
always wear eye protection (safety gog-
gles). Wearing personal protection equipment
as a dust mask, nonslip safety shoes, safety
helmet or ear protectors (depending on the
type and application of the tool) reduces the
risk of injury.
that the power tool is switched off before
you connect it to the mains supply and/or
the battery and whenever you pick up or
carry the tool. When carrying the tool with
your finger on the on/off switch or connecting
the tool to the mains supply with the switch
in 'ON' position, this may result in accidents.
and the like before you switch the power
tool on. A wrench or other tool that is inside
or on a rotating part of the tool may cause
injury.
have a safe footing and keep your balance
at all times. This will allow you to better con-
trol the power tool in unexpected situations.
clothing or jewellery. Keep your hair,
clothes and gloves clear of all moving
parts. Loose clothing, jewellery or long hair
may get caught in moving parts.
provided make sure that they are connect-
ed and used properly. The use of a dust
extraction device may reduce risks caused
by dust.