Twin-Star International Duraflame 9HM7253 Mode D'emploi page 5

OPERATION INSTRUCTIONS
FUNCTION
POWER
▲ ▼- SETTING TEMPERATURE
TIMER
COOL DOWN CYCLE
A165
ICON DESCRIPTION
The POWER button supplies power to all the functions of
the heater. Pressing the POWER button again the heater will
be put in standby mode.
Pressing and holding the POWER button on the control
panel for 3 seconds will switch between °F and °C.
When pressing the ▲ ▼ buttons the display will enter
temperature setting mode.
When in temperature setting mode pressing the ▲ ▼
buttons will change the thermostat by 1 °F (1 °C.)
The temperature setting range is between 50 °F - 97 °F
(10 °C - 36 °C).
The default temperature is 72 °F (22 °C.)
After 10 seconds without control input the display will exit
temperature setting mode and show the current ambient
temperature.
There are 9 timer settings and OFF that can be selected.
OFF(00), 30min, 1Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H.
Double-digit minute settings, such as: 30 minutes are:
A digital plus a "H" show hours setting, such as:
2 Hours are:
If the timer function was previously set the first press
of the timer button won't change the previous setting.
Pressing the timer button will activate the timer display.
When the timer is active, the display will count down from
60 seconds before shutting off the heater.
After the heater has ran the fan will continue to run for a
period of time to cool down the internal parts.
5
www.tsicustomerservice.com