Cardo Systems SCALA RIDER Guide D'utilisateur page 5

Audio and Corded Microphone User Guide
POSITIONING THE SPEAKERS
Attach the speakers to the Velcro inside your helmet
opposite your ears (short speaker cord for the left ear
[A] and the long speaker cord [B] for the right ear).
You may want to use the supplied Velcro pad.
Using two speakers inside the helmet may be
prohibited in certain jurisdictions. If this is the case,
you should tuck away the long corded speaker
underneath the helmet padding as follows:
Lead the speaker cord [B] alongside the rim of the
padding to the right side and then back
to the left side, near speaker [A]. Then place the
speaker [B] underneath the padding.
QG Corded Microphone_011 QG0156.indd 5
USING THE MP3 PLAYER WITH YOUR HEADSET
Your SCALA RIDER helmet clamp can be connected to an MP3 player by
simply plugging it to the Helmet Clamp's jack with the MP3 cable as follows:
Speaker A
1. Power on the headset to have it on Standby mode,
flashing slowly in Blue.
Speaker B
2. Connect one side of the MP3 cable to your MP3
Cable
player jack and the other side to the helmet Clamp's
Speaker B
jack as shown in the photo.
NOTE: Operate the MP3 Player by using its buttons
(FF/REW/PLAY/PAUSE).
Volume can only be adjusted through the MP3 Player.
Speaker B
Any other audio connection will automatically mute the MP3 Player. The audio
signal will return only when headset is once again in Standby mode.
Speaker A
Connect the MP3 cable to
the helmet Clamp's jack
5
2/9/09 6:49:36 PM