Cardo Systems SCALA RIDER Guide D'utilisateur page 4

Caution: This process can be done only once!
1. Use the enclosed Allen Wrench to remove both Allen screws and
release the Helmet Clamp's back plate.
2. Determine the location on the helmet where the Helmet
Clamp must be attached so that the microphone is
located opposite your mouth. You may need to reposition
the Clamp repeatedly until you identify the best spot. (Be sure to clean
the selected area prior to the gluing process as described in # 3 below)
3. Use the pre-moistened Towelette to clean the helmet area where you
want to install the Glue Plate. Allow to dry thoroughly.
4. Peel the foil cover from the Glue Plates' adhesive pad.
5. Place the Glue Plate into position according to previous instructions
(clause #2).
Press firmly on all 3 parts of the Glue Plate for 15 seconds.
4
QG Corded Microphone_011 QG0156.indd 4
Audio and Corded Microphone User Guide
6. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
7. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
8. Peel the foil cover from the adhesive Velcro pad
and place the Velcro pad on the chosen location
opposite your mouth.
9. Attach the microphone on the Velcro, as in photo
10. Tighten the screws of the Clamp.
2/9/09 6:49:28 PM