SWAGTRON PRO Mode D'emploi page 22

Powered Acceleration Start
This is the default start setting. Follow the instructions below.
Step 1. Press the POWER key for 2 seconds to turn the scooter on.
Step 2. Carefully step on with one foot and stand upright but relaxed.
Step 3. Balance with both feet on the scooter and use the throttle to start powered acceleration.
Step 4. To stop riding, release the throttle and use the handbrake, footbrake, or both to gradually coast to a
stop then step off the scooter one foot at a time. Be extra cautions when dismounting for the first time.
Manual Acceleration Start
To use this start setting, please refer to P 04 in Section 2.5 then follow the instructions below.
Step 1. Press the POWER key for 2 seconds to turn the scooter on.
Step 2. Carefully step on with one foot and stand upright but relaxed.
Step 3. Keep one foot on the ground and kick off to begin accelerating manually.
Step 4. Once the Swagger reaches approximately 4 mph (6km/h), press the throttle to start powered
acceleration.
Step 5. To stop, release the throttle and use the handbrake, footbrake, or both to gradually coast to a stop then
step off the scooter one foot at a time. Be extra cautions when dismounting for the first time.
18
ENGLISH