Charging - SWAGTRON PRO Mode D'emploi

2.6 CHARGING

CHARGE THE SWAGGER BEFORE USING IT.
The charge cycle is complete when the battery icon on the display is full and/or the charger's light is green.
After this initial charge, use the scooter until battery level reaches approximately 10% (Battery Level indicator
will show one bar) before recharging.
Each charge cycle from zero to full charge will take approximately 1.5 hrs. When the backlit display on the
handlebars indicates battery power is low, recharge the Swagger. To recharge the Swagger, use the included
charging cable and its adapter.
Step 1. Ensure the scooter is turned off before charging and remains off while charging.
Step 2. Remove the cap covering the charger port.
Step 3. Insert the appropriate end into the scooter's stand and then insert other end into a wall outlet.
Step 4. While the scooter is charging, the charger light will be red.
Step 5. When the scooter is fully recharged, the charger light will turn green. You may then disconnect the
scooter from the charger.
DO NOT under any circumstances use the scooter while it is charging or connected to
the charger.
The charging time is approximately 1.5 hours. Charging longer than that may affect
battery life and/or performance. If the charger's light doesn't turn on, it may not be fully
connected. Check that it is securely connected to the wall and to the scooter.
14
ENGLISH