Publicité
RF Exposure Information
This device is tested and meets the government's requirements for exposure to
radio waves. This device complies with applicable limits for exposure to radio
frequency (RF) energy set by the FCC.
Specific Absorption Rate (SAR) refers to the rate at which the body absorbs RF
energy. The SAR limit set by the FCC is 1.6 W/kg. Testing for SAR is conducted
using standard operating positions accepted by the FCC. During testing, the radio
is set to its highest transmission levels and placed in positions that simulate use
against the body.
The FCC has granted an Equipment Authorization for this device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines.
SAR information on this device is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/eot/ea/fccid after searching on FCC ID:
" PD9AX211NG " and " Contains IC : 1000M-AX211NG "
Any changes or modifications not expressly approved by Intel could void
your authority to operate the equipment.
Canadian Department of Communications Compliance Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the
Canadian Department of Communications. This device complies with industry
Canada licence-exempt RSS standards(s). Operation is subject to the following
two conditions: (1) this device may not cause interference and (2) this device
must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil numerique német pas de bruits radio électriques dépassant
les limites applicables aux appareils numériques de la classe B prescrites dans le
Réglement sur le brouillage radioélectrique édicté par le ministére des
Communications du Canada. Le Présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio exempts de licence.
L'éxploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioéelectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Regulatory Information
13
Publicité
