AC OPERATION
Unwind he AC power cord and extend it to its full length. Insert
the AC power cord into any convenient 120V 60Hz household
outlet.
Please note that this unit is equipped with a polarized AC plug
which has one blade wider than the other. This is a safety feature to reduce the likelihood of electric
shock. This polarized AC plug will only fit in a polarized AC outlet. If you find that you cannot insert this
plug into your outlet, you may have an obsolete non-polarized outlet. Please do not try to defeat this
safety feature by using a non-polarized adapter or by filing the wider blade to make it fit into your outlet. If
this plug does not fit into your outlet, you should contact a qualified licensed electrician to replace your
obsolete outlet.
SPEAKER CONNECTION
1.
Place the speakers in convenient locations on either side of the unit. Usually a distance of five to
eight feet between speakers provides the best stereo effect, but this may vary depending on the size
and acoustics of the room.
2.
Locate the Speaker Terminals on the rear of the unit and connect the left speaker to the Left jack and
the right speaker to the Right jack.
CAUTION:
Only connect the speakers which are supplied with the unit. The use of any other or
additional speakers may cause damage to the unit. Never operate the unit without the speakers
connected.
REMOTE CONTROL BATTERY INSTALLATION
The battery compartment is located on the rear of the remot control.
1.
Remove the battery compartment door by pressing in on the tab and lifting it off.
2.
Insert two (2) AAA size batteries into the battery compartment as shown to the
right. Be sure to observe the polarity marking which are engraved inside the
battery compartment. If the batteries are inserted incorrectly, the remote control
will not operate.
3.
Replace the battery compartment door.
Follow these precautions when using batteries in this device:
1.
Use only the size and type of batteries specified.
2.
Be sure to follow the correct polarity when installing the batteries as indicated in the battery
compartment. Reversed batteries may cause damage to the device.
3.
Do not mix different types of batteries together (e.g.Alkaline and Carbon-zinc) or old
batteries with fresh ones.
4.
If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture.
(Follow battery manufacturer's directions.)
PREPARATION FOR USE
BATTERY PRECAUTIONS
4