Listening To The Radio - Citizen C300MSC Guide D'utilisation

LISTENING TO THE RADIO

1
Press the POWER/STANDBY button to turn
the unit on; the STANDBY indicator will go
out and the display's backlight will light.
3
Press the BAND button to select AM or
FM.
NOTE: If you select the FM band, be
sure to extend the FM Wire Antenna.
ANTENNAS:
FM–Make sure that the FM Wire Antenna is extended to its full length. You may have
to vary the direction of the antenna to find the strongest signal for each FM station.
AM–The AM ferrite bar antenna is located inside the unit. It may be necessary to turn
the unit slightly so that the internal antenna is pointing in the direction of the AM
transmitter. You may have to experiment to find the position that provides the
strongest reception for each of your favorite AM stations.
TUNING:
MANUAL TUNING: Repeatedly press the Skip/Search/Tuning o or n button to
manually advance the frequency in the display up or down until the desired frequency
appears.
AUTOMATIC TUNING: Press and hold the Skip/Search/Tuning o or n button until the
frequency in the display starts to scan, and then release the button; the tuner will
search and then stop on the next strong station it finds. Repeat this procedure until
the desired frequency appears in the display.
OPERATION (CONTINUED)
9
2
Repeatedly press the FUNCTION button
to select the Radio mode.
4
1
Press the Skip/Search/Tuning o 1 or n 2
button to select a station (see Tuning note
The station frequency appears on
below).
the display. Adjust the VOLUME control
as desired.
NOTE: If the FM band is selected and you
have tuned to an FM Stereo station, the FM
Stereo indicator will light in the display.
3
2
3