Watts SmartStream UV WB001 Mode D'emploi page 17

Start Up Screen
Normal Operation
Possible Alarms
Upon start-up of the system, if the UV sensor is
not found, the user will be notified via this screen.
The system will continue to the Home Screen
when a UV sensor is not found and display the
warning message.
The lamp identifies its self via radio frequency. If
the wrong lamp is used in a system this message
will appear during start up.
Every 15 seconds the screen will change from
the Invalid Lamp Type message to the Name of
Dealer message. Touch on the QR Code to dis-
play the correct lamp QR code in full.
17
System checks are automatically executed by
the controller in the Start Up Screen then
the system advances to the Lamp Warm Up
Screen. If an abnormal condition exists, a variety
of alarms can be displayed.