Favero MICRO8 Livret D'instructions page 8

ENGLISH
MICRO8
NOTES ON THE INSTALLATION
FEED: 185-240V~ 50-60Hz 30 mA.
ATTENTION: REMOVE THE POWER SUPPLY
BEFORE OPENING THE CASE.
Equipment: Class II.
The producer declines every responsability
in case the equipment is tampered with.
The power outlet must be near the
appliance and easily accessible.
If the appliance has to be connected to the
power supply permanently, its connection
must be carried out by qualified personnel
who must install an external cutoff device
in an easily accessible position.
PROGRAMMING MICRO8
Insert the plug in a 230Vac outlet and then
use the ON/OFF button to turn the device
on.
Before using the machine, it would be
best to carry out all the programming so
that each function you wish to use will be
activated.
To s t a r t p r o g r a m m i n g , t u r n t h e
INSTALLATION key in the direction of the
arrow until the red LED situated on the
yellow TOTAL button starts flashing. The
y e l l o w b u t t o n s a r e u s e d d u r i n g
p r o g r a m m i n g f o r m o d i f y i n g t h e 6
available functions, which are:
TOTALS
TOTAL
By pressing the TOTAL button, its LED
will start flashing.
The display will show the sum of the
totals for the 8 tables.
To display the total for each table, keep
the button corresponding to the table
pressed.
8
To reset all totals, press the buttons
TOTAL and (-) together. The maximum
value of the overall total is made up of 9
digits (999999999), whilst the maximum
value of each single total is made up of
8 digits (99999999), after which they will
restart from 0. As only 7 digits are
displayed, if the totals reach 8 or 9
digits, the two least important digits to
the right will not be shown. Decimal
points will however move so as to avoid
c r e a t i n g e r r o r s w h i l s t r e a d i n g t h e
numbers.
1
MONETARY UNIT
MONETARY
U N I T
By pressing this button, the number "1"
will flash on the left of the display, whilst
the value of the monetary unit (currency)
will appear on the right which can be
changed by using the buttons (+) and
(-), as follows: 0,05 0,10 0,20 0,50 1
2 5 10 20 100 200 500 1000.
This value depends on the currency
used and the required rounding off of the
sum to be paid.
For example: EURO 0,05 , USA 0,10 ,
RUSSIA 1 , JAPAN 10.
2
BILLIARD BALL BOX (enable)
BOX
By pressing this button, the number "2"
will flash on the left of the display.
The MICRO 8 can be connected to a
CONTROL-BALL-8 which can control the
billiard balls contained in special BOXES
for 8 billiard tables.
In this programming step, you decide
wich billiards has the BOX to control the
balls.
By pressing a numbered button
you can turn on or off the corresponding
f l a s h i n g l i g h t . I f i t i s o n t h e
corresponding billiard table will have a
ball BOX. For connecting the BOXES,
refer to the chapter "CONTROL-BALL-8".
ENGLISH
(1-8),