Zeus audio SPL-P2100 Mode D'emploi page 6

Description of the Functions
1. Mounting holes
2. CROSSOVER
3. FREQ
4. BASS BOOST
5. GAIN
6. INPUT
7. LINE OUT
8. Left Channel + -
9. Right Channel + -
10. POWER / PROTECTION
11. FUSE
12. REMOTE
13. B+
14. GND
Specifications
Power Max. ........................................................................................ 2 x 100W
RMS @ 4 Ohm........................................................................... 2 x 45W
THD ................................................................................................................. < 0,1%
Frequency range .....................................................................................10Hz-35kHz
S/N Ratio ......................................................................................................... > 90dB
Input sensitivity ...................................................................... 200mV – 6V adjustable
Crossover frequency ............................................. Low: 30Hz – 300Hz, High: 150Hz
Dimensions ....................................................................................184 x 265 x 55mm
All manuals and user guides at all-guides.com
Two on each side of the unit
Switches the crossover function on and off
Sets the crossover frequency
Switched for enhanced bass reproduction
Set the input sensitivity
RCA sockets for the input signal from the head unit
Output to another amplifier
Connection terminal for the left speaker
Connection terminal for the right speaker
LED lights up in green when the amplifier is switched on and in red
when the protection circuit has been triggered
Fuses
ON/OFF switch contact
Positive power terminal
Negative (ground) terminal