Processor Operations; Selecting A Component - Sony SDP-E800 Mode D'emploi

Processor Operations

Selecting a Component

To listen to or watch a connected component, first
select the function on the processor or with the remote.
Before you begin, make sure you have:
• Connected all components securely and correctly as
indicated on pages 4 to 7.
• Turned MASTER VOLUME to near the centre
position (when using an amplifier with 5.1 ch
inputs).
• Turned MASTER VOLUME to the leftmost position
(when using separate amplifiers for each speaker).
DIGITAL 1~3 and
ANALOG buttons
POWER
1
Press POWER to turn on the processor.
2
Select the component you want to use:
To listen or watch
An LD or DVD player connected
to the DIGITAL 1 input jacks.*
Digital components connected to
the DIGITAL 2 or 3 input jacks.
An analog component connected
to the ANALOG input jacks.
1
* This unit's digital inputs detect Dolby Digital (AC-3)
or PCM signals automatically. (The AC-3 RF input
terminal for use with LD players is for Dolby Digital
(AC-3) signals only.)
* 2 Press repeatedly to choose the appropriate input
jack for the DIGITAL 1 audio signals (AC-3 RF),
(OPTICAL) or (COAXIAL).
3
Select the 5.1 ch input on your multi-channel
amplifier and make sure the amplifier's video
selector is set appropriately (see page 6).
EXAMPLE: Turn FUNCTION to select "LD", then press
5.1 INPUT (for Sony TA-VA8ES). At this time, set the
MASTER VOLUME control on your amplifier to "0".
4
Turn on the source component, the LD player for
example, and start playback.
MASTER VOLUME
Press
DIGITAL 1
1 repeatedly* 2
DIGITAL 2 or 3
ANALOG
5
Use the MASTER VOLUME on your multi-
channel amplifier to adjust the volume.
To Do This
Mute the sound Press MUTING on the remote.
Press again to restore the
sound.
Reinforce the bass Press BASS BOOST to turn
on the BASS BOOST
indicator.
Turn off the display Press DISPLAY on the remote.
Adjust the level of the Press SUB WOOFER +/–
sub woofer on the remote.
Z
Using the remote
1
Press POWER on the front panel to turn on the
processor.
2
Press INPUT SELECT < or > repeatedly to display
the input for the component you want to use.
The inputs change as folllows each time you press
INPUT SELECT.
.
DIGITAL 1 (AC-3 RF)
<
DIGITAL 1 (OPTICAL)
<
DIGITAL 1 (COAXIAL)
<
DIGITAL 2
<
DIGITAL 3
<
ANALOG
>
INPUT
SELECT
< >
11 GB