Replacing Halogen Lightbulbs - Newage SKU Guide D'installation Et Mode D'emploi

Replacing Halogen Lightbulbs

• Disconnect grill at power source before replacing lightbulbs
• The oil from your fingertips will reduce the life of the bulb. It is recommended to touch the bulb
as little as possible and to wipe the bulb with a cloth after handling with bare fingers.
To replace the halogen bulb in your grill you must first remove the lens from the light housing. To
remove the lens from the housing, remove the Philips screw securing the housing in place. Snap the
lens out of the housing (including the metal bracket). Reach in using your fingers only, grip the two
outside edges of the light bulb, do not grip the top or bottom of the bulb, as it might break. Insert
the new bulb using your clean cloth and gently snap it into position.
Begin by unplugging the grill from the
power supply. Remove the screw holding
1
the light housing to the grill using a #2
Phillips screwdriver.
With the light cover removed pull the
3
halogen bulb out from light socket.
100w/12V
49
NOTE
Carefully pull the housing out from grill,
it will be attached by electrical wire so do
2
not pull hard. Remove the clip holding the
light cover to the main light housing.
Replace bulb by pushing straight into
light socket. Re-attach light cover, and re-
4
install housing repeating steps 2. and 3. in
reverse order.
A