Elcometer SAGOLA mack 150 Manuel D'utilisation page 41

40/41
Pay adequate attention when handling the unit in order to prevent any damage that might lead
to dangerous situations for the user or personnel standing near the unit, as a consequence of
leaks, breakages, etc.
The equipment has been designed for use at room temperature. The maximum operating
o
temperature is 50 C.
The use of solvents and/or detergents that contain halogenated
hydrocarbons (trichloroethane, methyl chloride, etc.), may cause
chemical reactions in the unit as well as in its zinc-coated components
(trichloroethane mixed with small amounts of water produces
hydrochloric acid). For this reason, these components may rust and
in extreme cases the chemical reaction caused may be explosive. We
recommend you to use products that do not contain the aforementioned
components. Do not use acids, soda (alkalis or pickling substances, etc.)
for cleaning under any circumstances.
In general, precautions must be taken whenever the unit is handled, in order to prevent any
damage to this.
Connectors must be securely tightened and in good condition. If pneumatic connectors are
fitted, they must comply with the standard ISO 4414:2010.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this manual may lead to incidents affecting the
physical integrity of the user or other personnel or animals.
Respect and comply with indications relating to the conservation of the environment.
Always keep the safety sheets for the products to apply and the cleaning liquids to hand in case
you need to consult them.
14. Observations
By following the instructions set out in this manual you will ensure good spraying and quality of
finish. Should you have any doubt, please contact the Technical Service of SAGOLA.
15. Warranty Conditions
This device has been manufactured with great precision and has been subjected to a large
number of controls before leaving the factory.
The WARRANTY is valid for 3 years, counted as of the date of purchase, which will be indicated by
the seller in the place provided for this purpose, together with his stamp. Once the unit has been
received, please complete the warranty and send this to the manufacturer for validation
This WARRANTY covers any manufacturing defect, which will be repaired without charge.
However, any malfunction resulting from the incorrect use of the unit, such as inadequate
connections, breakage due to dropping, or similar, the normal wear of components and in general
any deficiency not attributable to the manufacturer of the device, are expressly excluded. Likewise,
the WARRANTY shall be rendered null and void when it is evident that the unit has been handled
by persons other than our Technical Assistance Service.
This WARRANTY does not support any undertaking made by anyone outside our Technical
Service.
ENGLISH