Elcometer SAGOLA mack 150 Manuel D'utilisation page 33

32/33
08.4. Classification according to the ATEX directive
The machine conforms to the essential requisites of the EU Directive 2014/34/UE, better known
as ATEX ("Explosive atmospheres"). It is classified as group II category 3 letter G system. The
assessment procedures of conformity, carried out by an internal factory check, allow the installation
of the machine in surroundings where there may be potentially explosive atmospheres due to the
presence of gas, fumes or mist.
08.5. Equipment assembly
You must always connect the equipment and all the elements involved in
the work process to a grounding connection to eliminate static electricity.
09. Start up
Before each start-up and especially after cleaning or repairing the unit, a check must be made that
all its elements are securely tightened.
The first time you use your equipment there is no need to depressurise it, as it is already supplied
in a totally depressurised state, though it will be necessary to do this each time any maintenance
or repair work is carried out.
Should this safety measure not be observed, this may lead to malfunctions, personal injury and
accidents, which may prove to be fatal. SAGOLA S.A.U. does not accept any responsibility for the
consequences of any non-compliance with these safety regulations.
Only if the whole process indicated in the section regarding
DEPRESSURISATION, described in section 10, has been correctly carried
out will the unit be ready to be started and used again.
The incorrect observance of this Depressurisation process could lead
to malfunctions in the equipment and deterioration of its components.
ENGLISH