Installation -Speakers - Rockford Fosgate Power T152S Installation Et Fonctionnement

NOTE:When NOT bi-amping the crossover, connect to the MID inputs only.The jumpers must
be in the "Normal" position.
Connect
from Source
or Amplifier
Use this section when installing Systems
1. Cut the proper size hole for the speaker.
NOTE: See Specifications for proper hole size.
2. Place the mounting ring over the mounting hole and mark the location of the screw mounting holes.
3. Remove the ring. Drill the holes for the screws using a 1/8" drill bit.
4. Route the wire through the mounting hole cut-out.
5. Attach the wires. Observe proper speaker polarity.
6. Place the mounting ring over the speaker.
7. Place the speaker into the hole and screw the speaker into place.
Mounting Hole,
Cut-Out
Example of speaker installation
Speaker
I -S
NSTALLATION PEAKERS
Mounting Ring
Screw
7