CAPTELEC S 0600 Manuel page 10

S 0600 / H-600
2) Installation of the receiver
Plug the receiver into the outlet. The receiver will perform better if keeping it away from electric equipment.
Try adjusting the location of the receiver according to the "Range Guide".
Thanks to its range of 100m, you can entrust it to one of your neighbors for example.
3) Operation
- Sound adjustment : Use the volume control button ⑤ to adjust the volume to your convenience (3 levels + silent).
- Melody choice: Press the ringtone choice button ④ to choose one of the 32 available melodies then press the setting
button ③ to validate and press the bu on ⑧ on the transmi er within 5 seconds to confirm the choice of the ringtone.
The device with memory function, every time you unplug and then plug the receiver back in, the melody and volume keep
the same.
In an emergency, press and hold the SOS button for at least 3 seconds to activate the SOS alarm.
4) Transmitter/receiver synchronization
To synchronize the transmitter and receiver, press the set button ③, the device will ring 1 me and press the transmi er
button ⑧ within 15 seconds. The receiver will ring 1 time and flash to confirm that the pairing has been completed.
It will automatically return to normal mode after a few seconds.
Note: The chime has an internal memory where it stores the codes of the currently paired buttons in case of power failure.
Therefore, it is not necessary to re-pair the buttons after a power failure or blackout.
C. TROUBLE SHOOTING
Receiver does not ring
No indicator light
Reduced transmission
distance
D. CARE AND MAINTENANCE
Clean the product only with a dry or slightly damp, lint-free cloth.
Do not use abrasive cleaners to clean the unit.
E. FEATURES
- Material: ABS
- Receiver: 110-220V <2.0mA
- Transmitter: 1 x CR2032 3V <10mw
- Frequency 433.92 MHz
- Sound power : 25dB to 110dB
Make sure the receiver is properly plugged in and within range of the transmitter.
Change the transmitter battery.
Make sure the receiver is properly plugged in and within range of the transmitter.
Change the transmitter battery.
Metal structures or a door frame may interfere with the signal. Move the transmitter or
receiver.
Make sure other electrical devices that may interfere with signal reception are not near the
receiver. Move the receiver.