Publicité
MWR21
Location and Mounting
Choose and Prepare Location
The MWR32 is designed to be installed in a standard 2 1/8" gauge cutout.
The required mounting depth will vary, but at least 2 1/2" is needed to
mount the remote control.
If a standard cutout is not available, use the template provided to mark an
area for the cutout and carefully cut an opening with a hole saw. A jig saw
can be used but may cause difficulty because of the small radius of the
required opening. Be sure to check behind the panel for wiring harnesses,
steering cables, hydraulic lines, fuel lines, gas tanks, etc. Also check to
make sure you can get behind the dash panel, bulkhead, etc. to attach the
mounting bracket.
Important: Do not mount unit where it can be submerged or
subjected to high pressure spray.
Template / Plantilla / Gabarit
6
Publicité
