Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROLLER operation – picture E
The remote controller transmits signals to the system.
Button "A" - the appliance will be started when it is energized or will be stopped when it is in operation, if you press
this button.
Button "B" - press it to select operation mode: cool mode
Button "C" / "D" - press to fix required room temperature when cooling mode is switched on.
Button "E" - press to set up or cancel sleep mode.
Button "F" - press it to select fan speed in sequence: low / high wind speed.
Button "G" - press it repeatedly to setup the operation time from 1 to 24 hours.
Button "H" - press to set up or cancel air flow oscillation function.
PROTECTION DEVICES
Compressor protection: Three minutes later after power on / restart, compressor starts to run.
DRAINAGE INSTRUCTIONS:
This device is equipped in auto-water-evaporating system. Condensed water cycle will cool down the condenser,
which will not only improve cooling efficiency, but also save energy.
1. If inner water tank is full, "M" control lamp will flashed on the screen, the device enter into standby mode, buzzer
shouts, compressor stops and all buttons is invalid till the device recovers to be normal, after water drainage.
2. Pull out the plug to drain out water, power off the device.
3. Remove the rubber cap from the drain hole (8) – picture F1. Drain the water to flat container (not included to
set) or by pipe (not included to set) - picture F2. Close the rubber cap (8).
4. Restart the device, the machine will runs normally.
CLEANING & MAINTENANCE
Cleaning: before cleaning and maintenance, turn off the device and unplug the plug.
a) Housing cleaning
Clean with surface of device with a wet soft cloth. Don't use chemicals, such as benzene, alcohol, gasoline,
otherwise, the surface of the device will be damaged or even the whole machine will be damaged.
b) Net filters cleaning
If the filter is clogged with dust, then the effectiveness of the device is reduced, be sure to clean the filter once
every two weeks.
- Clean the upper and down filters frame after remove them from the back side of device – picture G.
- Put the filter into warm water with neutral detergent (about 40℃ / 104℉) and dry it in the shade after rinsing
clean.
STORAGE
If the device will be unused for a long time, please do as following :
1.
Pull out drainage plug (8) to flow out water.
2.
Let the device runs under fan mode for 2 hours to dry out the device's internal.
3.
Turn off the device and pull out plug .
4.
Clean and dry filters, then reinstall them.
5.
Pull out exhaust pipe for safe keeping .
6.
Put the machine into plastic bag , and place it on a dry place.
7.
Remove batteries of the remote control and keep them properly.
→
→
dry mode
fan mode.
7
Publicité
