Publicité
Les langues disponibles
Les langues disponibles
Operation, Care and maintenance, Troubleshooting
2.4 After emptying
Closure cap of the drain hose (12, page 3) screws firmly.
☞
When dirty, rinse sieve in the tank cover with clean water (otherwise suction power is reduced).
☞
2.5 After operation
Set machine parking lever (X).
☞
When you have finished cleaning the carpet, clean the brush tunnel. This is easier if you remove the brush first (see
☞
Replacing the brush), Clean the underside of the machine with a damp cloth.
Waste water tank emptied via the drain hose.
☞
Waste water tank with clean water and rinse empty.
☞
3
Care and maintenance
3.1 Important safety notes
Always disconnect mains plug before working on machine!
Only carry out maintenance and repair work described in the operating instructions.
Always leave servicing and repair work, especially the elimination of electrical faults to the
customer service staff or to an authorised specialist.
3.2 Replacing the brush
a b
8
4. Troubleshooting
Fault
Machine does not run
Insufficient suction
No water
Insufficient supply of cleaning agent
☞ Tilt
machine
back
☞ Unscrew mounting screw ( a ) next to relieve lever.
☞ Pull off bearing cover ( b ) in the direction of the arrow and remove together with the brush ( 8 )
towards rear.
☞ Position new brush on bearing cover and push both parts together as far as possible.
☞ Insert brush into suspension, making sure that both pins of the driver are guided into the holes
of the brush on the drive side.
☞ When the brush is in the correct position, secure the brush holder with the above-mentioned
bolt ( a ).
Cause
☞ Mains plug not connected
☞ Fuse blown
☞ Overheat protection has trippe
☞ Power supply interrupted
☞ Suction nozzle plugged
☞ Clogged nozzle
☞ Tank cover connection open
☞ Tank cover not properly fitted or
seal defective
☞ Suction sieve in tank cover plugged
☞ Sealing cap on discharge hose not
properly screwed on
☞ Spray nozzles clogged
☞ Lines or spraying jets plugged with
cleaning agent
onto
the
handle
(only
when
the
tanks
are
Remedying
Plug in mains.
●
Check fuse or earth.
●
Allow motor to cool.
●
Have supply line checked by
●
electrician.
Eliminate plugging.
●
Eliminate plugging.
●
Connect suction hose properly.
●
Fit tank cover properly or replace
●
seal.
Rinse sieve with clean water.
●
Check seal, screw on cap tightly,
●
replace if necassary.
Spray nozzles for clogging, clean
●
eventually.
Flush fresh water tank and line
●
system.
Rinse sieve in tank cover with water.
●
empty!).
Publicité
