Cafe CVW9304 Manuel De L'utilisateur Et Instructions D'installation page 19

3
INSTALL HOOD ONTO WALL
• Pull house wiring through knockout at the back or
top of the hood.
• Lift the hood and place over the hooks on the
installation bar. Allow the hood to slide down into
position.
• Check to be sure the hood is level and centered.
• Tighten wall anchor screws (C) to finish hood body
installation to the wall.
• Remove cover from junction box inside the hood.
Centerline of
Installation Space
1" = 2.5 cm; 1' = 0.3 m
49-2000706 Rev. 3
Installation Instructions
24" minimum over electric
range or cooktop, or 30"
minimum over gas range
or cooktop, and 36"
recommended maximum.
4 (Alternate Mounting Method)
INSTALL HOOD TO SOFFIT OR
CABINET
SKIP THIS STEP IF USING WALL MOUNTING
METHOD
IMPORTANT: Soffit or cabinet framing must be
capable of supporting 100 lbs.
When necessary the hood may be installed so that it
is supported by the soffit or cabinet.
• The soffit should be constructed with 2"x4"s.
• Use a level to draw the cooktop or range center
line.
• Continue the centerline forward on the bottom of
the soffit.
• Install horizontal wood supports between the 2"x4",
at distance A to the left and right, as per the table
below.
B
A
A
C
"A" "B"
Center-line Opening for
to Center Ductwork for
Stud top venting
30" 8-3/4"
Models
8-3/8"x11-1/4"
36" 13-3/4"
Models
"C"
Opening for
Ductwork for
back venting
10-1/2"x13-1/4"
19