Evenflo FlexLite PRO Mode D'emploi page 9

5A
5-pt Harness
H
G
K
L
J
I
H
Step 1
3-pt Harness
K
L
J
Note: Verify the in-seat fold locks on both sides are locked by lifting up
H
the rear of the stroller using the parent's handle.
G Lock the rear brakes and pivot the child's tray out of the way.
5-point Harness:
With the 5-point harness, the harness shoulder straps G must start at
shoulder height or lower and use the harness strap buttonholes H
closest to the baby's shoulders, as shown. To adjust the height of the
harness straps to the baby's shoulder height, do the following:
1. On the back of the stroller, insert each harness shoulder strap buckle
L
2. On the front of the stroller, insert each harness shoulder strap buckle
Step 2
H
5-point and 3-point Harnesses:
Place the baby in the seat and bring the crotch panel J up between
I
the child's legs. Fasten each buckle K. For a snug, comfortable fit,
pull the shoulder straps G to tighten the shoulder restraint (shoulder
restraint only for 5-point harness) and pull the waist restraint straps L
to tighten the waist restraint.
Note: To loosen the waist straps L, push in the release button M on the
buckle and pull.
Once the child is properly restrained, close and lock the child's tray. Make
sure the tray locks into position with audible clicks. Pull on the child's
tray to make sure it is locked into place.
To change from 5-point to 3-point harness:
Remove each harness shoulder strap G from each buckle K, as
shown. Remove both shoulder straps
from the stroller seat back. Store
shoulder straps for future use.
L
M
To avoid serious injury from falling or sliding out, ALWAYS use
I through the corresponding buttonhole H in the seat back, as
shown, and push it through to the front side of the seat back.
I from Step 1 through the corresponding buttonhole H at the
desired height location in the seat back, as shown, and push it
through to the back side of the seat.
USING YOUR STROLLER
WARNING
waist restraint.
G
K
7