inventiv 202104 Mode D'emploi page 20

202104
REMOVE THE SANDING PAPER
Simply remove the sanding paper directly.
SANDING PAPER WITHOUT HOOK & LOOP
SYSTEM (SEE FIG B , C , D)
FIT THE SANDING PAPER
Fit the sanding paper over the base. Make sure the
sanding paper is even with the edges and that the
dust collection holes in the base and sanding paper
is aligned and that the sanding paper is taut on the
base.
Lift the sanding paper retaining clips to the open
position and insert one end of the sanding paper
under the retaining clip.
Push the clip back into the retaining position. Lightly
stretch the paper over the base plate ensuring that
it is not folded or wrinkled then position under the
other retaining clip back into the retaining position.
Check that the paper is flat to the base plate, if not,
release either clip and reposition the paper before
resetting the clip. Switch on momentarily to check
that the sander is functioning correctly. If there
is undue vibration, repeat the paper positioning
procedure.
REMOVE THE SANDING PAPER
To remove the sanding paper, lift up the clamp lever
and move away from the clamp lever lock. The
sanding paper clamp is now loose. Repeat with the
other clamp on the opposite side of your sander.
2. USING THE CYCLONIC DUST BOX
A) ATTACH THE CYCLONIC DUST BOX (SEE FIG E1)
Your sander is equipped with a cyclonic dust box.
To attach, slide the box onto the outlet piece and
take care that the latching lever engages.
Caution: To prevent the possibility of sanding dust
or foreign body being thrown into your face or eyes,
never attempt to use your sander without the dust
box properly installed.
B) EMPTY THE CYCLONIC DUST BOX (See Fig E2 E3)
For more efficient operation, empty the cyclonic
dust box every 5-10mins. This will permit the air to
flow through the box better.
To empty the box, press the latching lever in and
pull off the box. Then press the button at the rear of
the box to open it, and shake out dust.
20
SAFETY AND OPERATING MANUAL