For Your Safety - Flex PE 8-4 80 Notice D'utilisation

PE 8-4 80

For your safety

WARNING!
Before using the polisher, please read and
follow:
these operating instructions,
–
the "General safety instructions" on the
–
handling of power tools in the enclosed
booklet (leaflet
the currently valid site rules and the
–
regulations for the prevention of
accidents.
This polisher is state-of-the-art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged. The polisher
may be used only
used as intended,
–
in perfect working order.
–
Faults which impair safety must be repaired
immediately.
Intended use
This polisher is designed
– for commercial use in industry and trade,
– for all types of polishing work with
polishing sponges, lambskins and
woolskins, felt plate, buffing disc
– for use with polishing tools which are
permitted to run at a speed of at least
4000 r.p.m.
Safety instructions for polishing
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries . Keep all safety instructions and
other instructions in a safe place for the
future.
no.: 315.915),
-
 This electric power tool must be used as
a polisher. Observe all safety information,
instructions, diagrams and data which you
receive with the power tool. If you do not
observe the following instructions, an
electric shock, fire and/or serious injuries
may occur.
 This electric power tool is not suitable
for grinding, sanding, for use with wire
brushes or for cut-off grinding. If the electric
power tool is not used as intended, the user
may be exposed to hazards and may be
injured.
 Never use accessories which the
manufacturer did not intend or recommend
especially for this electric power tool. Just
because you can attach the accessory to
your electric power tool does not guarantee
safe use.
 The permitted speed of the insertion tool
must be at least as high as the maximum
speed indicated on the electric power tool.
An accessory which rotates faster than
permitted may shatter and fly off.
 Outer diameter and thickness of the
insertion tool must correspond to the
dimensions of the electric power tool.
Incorrectly measured insertion tools cannot
be adequately shielded or controlled.
 Flanges or other accessories must fit
exactly on the spindle of your electric
power tool. Insertion tools, which do not fit
exactly on the spindle of the electric power
tool, rotate unevenly, vibrate violently and
may result in loss of control.
 Do not use any damaged insertion tools.
Before use, always check the insertion
tools for splinters and cracks. If the electric
power tool or the insertion tool is dropped,
check for damage or use an undamaged
insertion tool. When you have checked and
inserted the tool, ensure that you and
anybody in the vicinity remain outside the
plane of the rotating insertion tool and
leave the power tool running for one minute
at maximum speed. Damaged insertion
tools usually break during this test time.
5