Publicité
Les langues disponibles
Les langues disponibles
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, MAKE CERTAIN THAT THE POWER SUPPLY IS
OFF BEFORE INSTALLING OR SERVICING THIS FIXTURE!
NOTE: For Ceiling thickness and cutout dimensions refer Table 1.
For LTR-3SQD/SQW-H Fixtures - Top/Above Access Required for servicing Driver
Fixture Housing Mount with Hanger
1.
Install the fixture in the ceiling using the two hanger bars (1) (supplied), or mounting channel or bars (by others)
placed in the adjustable mounting brackets (2). Mount the fixture in the ceiling so that the weight of the fixture is
supported by the hanger bars, mounting channel, bar, and/or hanger wires secured to the building structure.
2.
Adjust the fixture so the bottom of the plaster flange opening is flush with the finished ceiling line and in alignment
with adjacent fixtures. Secure mounting brackets by tightening two wing nuts (3) on either side of the fixture.
3.
Determine where the supply wiring conduit will enter the J-Box, , remove knockout, and fasten the conduit in
conformance with the National Electric Code.
4.
Remove J-Box cover plate (4). Assemble using appropriate connectors for the supply wire used. Connect ground
wires to green ground leads. Connect white (common) to white lead(s). Connect power.supply (line) to black lead(s).
Reinstall J-Box cover (4). WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a
qualified electrician for all other options that require other wiring configurations.
5.
Pull electrical cover (5) and power cable down below ceiling through opening in fixture.
For LTR-3SQD/SQW Fixtures :
6.
Insert connector (6) into connector (7) and snap firmly together.
7.
Carefully route wires and connectors (6) & (7) into opening area on side of electrical box (8). Slide electrical cover
assembly (10) onto electrical box (8) by placing tab (9) on top of cover into notch (10) on top of box, then guide slot
(4) on cover over loosened thumb screw (5). Tighten thumb screw (5) to secure electrical cover assembly (10) to the
electrical box (8) to each other.
8.
Feed the electical box (10+8) and cable up through the 3x3 opening in the fixture panel and out of the way.
9.
Rotate two torsion springs (12) upward along the sides of the trim and insert through opening. Push trim assembly up
towards ceiling through the 3x3 opening until springs draw trim firmly against the ceiling. ( NOTE: For wall wash
fixtures, insert the trim so that the plastic lens faces toward the wall. See illustration on sheet 2)
3 IN SQ DOWNLIGHT TRIM
3 IN SQ WALL WASH TRIM
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND
PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millennium Blvd • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright
2022
, Revision
A
1
CEILING
(REFER TABLE 1
FOR CEILING
THICKNESS & CUTOUT)
KEEP THESE INSTALLATION INSTRUCTIONS
, All Rights Reserved - Printed in U.S.A.
Part No...........................................
4
3
2
TRIM
ASSEMBLY
12
93103420
Page 3 of 8
FIXTURE HSG
ASSEMBLY
10
1
9
5
8
4
6/7
10
12
Publicité
