Hubbell Prescolite LITEISTRY LTR-3SQD Instructions D'installation page 2

CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, MAKE CERTAIN THAT THE POWER SUPPLY IS
OFF BEFORE INSTALLING OR SERVICING THIS FIXTURE!
LENS
METAL REFLECTOR PANELS
Table 1
1
CEILING CUTOUT DIMENSIONS
Square Standard
Frames Downlight/Wall Wash
LTR-3**-H/RH
□3.31" (□84.1mm)
LTR-4**-H □4.75" (□120.7mm)
LTR-6**-H □6.69" (□169.9mm)
1
Ceiling thickness:
Minimum 1/2" Solid core,
Maximum-Refer to the respective spec sheets.
2
The LTR-3 cutouts can be made with a Sheetrock Saw with
attention to the cutout rough opening to accommodate the
reflector flange.
4 IN SQ WALL WASH TRIM
6 IN SQ WALL WASH TRIM
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND
PROPER OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
701 Millennium Blvd • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2022 , Revision A
CORRECT ORIENTATION OF WALL WASH TRIMS
Flush Mount
2 2
□3.94" (□100.1mm)
□5" (□127mm)
□6.88" (□174.8mm)
1
10
KEEP THESE INSTALLATION INSTRUCTIONS
, All Rights Reserved - Printed in U.S.A.
Part No...........................................
CEILING
WALL
LIGHT AIMED TOWARD
AND
PROJECTED ON WALL
13
4
3
2
6/7
5
8
93103420
Page 2 of 8
1
FIXTURE HSG
ASSEMBLY
CEILING
(REFER TABLE 1
FOR CEILING
THICKNESS & CUTOUT)
12
TRIM
ASSEMBLY