Recommended Accessories - Dremel ScrollStation 1830 Mode D'emploi

Recommended Accessories

Use only Dremel accessories. Follow instructions that accompany accessories. Use of improper accessories may cause hazards.
LEG SET Magnifier
Cat. No. Cat. No.
2615018500 2615018505
Cat. No. Suggested Usage
16412 For cutting wood 3/8" to 2" thick
16411 For cutting wood 3/16" to 1" thick
16413 For cutting wood thinner than 1/4" thick
The Pin-End blades, while somewhat easier to put in and take out of the machine, do not always produce the
same controlled cutting action provided with the Plain-End blade. These narrow Plain-End blades allow the
Cat.No. Suggested Usage
16453 For cutting hard and soft woods 1/4" to 2" thick
16446 For close radius cutting in materials 1/8" or thicker
Cat. No. Suggested Usage
16463 For wood, plastic and abrasive materials
For cutting precious and non-ferrous metals; these must be used at very slow speeds.
Cat. No. Suggested Usage
16483 Metals and other hardwood materials.
Provides a smooth, splinter free finish. Eliminates the need for excessive finish sanding, and
Cat. No. Suggested Usage
16431 For cutting hard or soft woods up to 1/8" thick.
16432 For cutting hard or soft woods 1/8" or thicker
Shapes and cuts ceramic tiles cleanly and accurately. Cuts intricate patterns easily in any direction.
Cat. No. Suggested Usage
16472 For close radius cutting in ceramic tile or thin wood.
Dremel offers both Pin- and Plain-End 5 inch blades.
PIN-END SAW BLADES
Pin-End blades permit relatively tight radius cutting in hard and soft wood.
user to cut more detailed, intricate patterns and smaller inside cuts.
Saws in all directions without turning the workpiece.
METAL PIERCING
They perform well on machines that have variable speed capability and
should be lubricated with beeswax, or a light machine oil.
REVERSE TOOTH
leaves a clean sharp edge on both the top and bottom of your workpiece.
PERMA-GRIT TUNGSTEN CARBIDE
Also use for thin wood. Not for use on ceramic floor tile.
Width Thick
.110" x .018" x 10
.110" x .018" x 15
.070" x .010" x 18.5
PLAIN-END
Width Thick
.062" x .020" x 9.5
.038" x .016" x 12.5
SPIRAL
Kerf
.034" - .036" x 41
Kerf
.033" x .016" x 36
Kerf
.029" x .012" x 20
.038" x .016" x 12.5
Kerf
.046" x .048"
17
TPI Speed
Any
Any
Any
TPI Speed
High
High
TPI Speed
TPI Speed
Low
TPI Speed
Any
Any
Grit Speed
120 Medium