Lexicon MPX 200 Mode D'emploi page 2

IMPORTANT SAFETY INSTRUCTIONS
Save these instructions for later use.
• Always use with the correct line voltage. Refer to the manufacturer's operating instructions for power requirements. Be advised that different operating
voltages may require the use of a different line cord and/or attachment plug.
• Do not install the unit in an unventilated rack, or directly above heat producing equipment such as power amplifiers. Observe the maximum ambient
operating temperature listed in the product specification.
• Slots and openings on the case are provided for ventilation – to ensure reliable operation and prevent it from overheating. These openings must not be
blocked or covered. Never push objects of any kind through any of the ventilation slots. Never spill a liquid of any kind on the unit.
• Never attach audio power amplifier outputs directly to any of the unit's connectors.
• To prevent shock or fire hazard, do not expose the unit to rain or moisture, or operate it where it will be exposed to water.
• Do not attempt to operate the unit if it has been dropped, damaged, exposed to liquids, or if it exhibits a distinct change in performance indicating the need
for service.
This unit should only be opened by qualified service personnel. Removing covers will expose you to hazardous voltages.
• Take precautions not to defeat the grounding or polarization of the unit's power cord.
• Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of fire or electrical shock.
• Route power supply cords so that they are not likely to be walked on or pinched by items placed on or against them, paying
particular attention to cords at plugs, convenience receptacles, and the point at which they exit from the unit.
• The unit should be cleaned only as recommended by the manufacturer.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.