Mediaone Series Rear Panel Layout - Samson MediaOne 3a Mode D'emploi

MediaOne Series Rear Panel Layout

MediaOne Series Layout
1
MediaOne 4a and 5a
1 RCA INPUT – Used to connect signals
from unbalanced, –10dBV devices. The
Red connector is the for Right input and
the White is for the Left input.
2 LEFT SPEAKER OUTPUT – Push
Terminals for connecting the Left-side
Extension Speaker.
3 POWER SWITCH – Main power switch.
When set to the ON position, the front
Rear Panel Layout (left speaker)
B B
2
3
4
5
A
1
MediaOne 3a
panel blue LED illumintes indicating
the MediaOne Series is powered up and
ready for operation.
4 AC INLET - Connect the supplied IEC
power cable here.
5 VOLTAGE SELECTION SWITCH - This
switch is used to select the amplifiers
operating voltage. NOTE: Bure sure it
is set to the correct voltage for your
country.
A TERMINAL CUP – Push Terminals for
connecting the Left-side Extension
Speaker.
B TUNED PORT - Quiet port design
offering linear extended low
frequency response.
4
2
5
3
4