7LS FA7-1400J Manuel D'instructions page 8

2. Cleanse skin and remove makeup before use. Gel, serum, moisturizer, or cream (not
included) must be applied to the skin in combination with the steps below to ensure
conductivity and proper operation. Gels, serums, moisturizers, or creams containing
AHA or other anti-aging acids or ingredients should not be used.
3. Attach the eye and lip attachment to the body of the device. Press the power
button 1 time to turn the device on. Adjust the intensity level to your comfort by
pressing the + or - button located on the front of the device. The default intensity level
is 0 (no microcurrents).
4. Press the spheres onto your face. Lift and hold skin in place for 5 seconds or gently glide
the device in a linear, upward motion. See drawing for more details.
5. The device will automatically shut down after 10 minutes of continuous use. Follow
up with your daily skin care routine after treatment.
6. For best results, use this treatment for 10 minutes, 2-3 times per week.
R ē S C U L P T R E D P H O T O N L I G H T T R E AT M E N T
1. Use the red photon light attachment to target wrinkles, fine lines, dark spots, and even
out skin tone while helping to promote collagen production.
2. Cleanse skin and remove makeup before use.
3. Attach the red photon light attachment to the main body of the device.
4. Put on the eye protection goggles.
5. Press the power button to begin treatment.
6. Place the lights in direct contact with the skin and hold for 5-8 seconds before moving
to the next area. You can treat your entire face using this technique.
7. The device will automatically shut down after 10 minutes of continuous use. Follow
up with your daily skin care routine after treatment.
8. For best results, use this treatment for 10 minutes, 2-3 times per week.
CAUTION: Always wear eye protection goggles when using the photon light therapy. It is
dangerous and harmful to your eyes to look directly into the lights.
I N T E N S I T Y L E V E L S E T T I N G S
There are 4 intensity levels for the microcurrent treatment. We suggest starting with the first
level and gradually increasing it over time depending on your comfort level. The default
intensity level is 0 (no microcurrents).
1. Press the power button and intensity level 0 begins (1 blue light appears).
2. Press + 1 time: switch to intensity level 1 (2 blue lights appear).
3. Press + 2 times: switch to intensity level 2 (3 blue lights appear).
4. Press + 3 times: switch to intensity level 3 (4 blue lights appear).
5. Press + 4 times: switch to intensity level 4 (5 blue lights appear).
6. Press - to lower the intensity level.
8