Publicité
Les langues disponibles
Les langues disponibles
Notice technique Escalier de rayonnage 02271 105 à 115
Operating manual Shelving ladder 02271 105 à 115
2.2 Access
Barrier manipulation
before access to the
platform.
2.3 Product displacement
2.4 Works position
3. Using advice
+ Do not use the platform without guardrail or behind an unlock door
+ Use the plateform on horizontal and non slippering surface
+ All the plateform's foots must be touch the ground.
+ On soft ground, it is essential to have a plate under all the feet concerned.
+ Assure than the working area is is away from any live electrical conductors.
+ The platform must not be used or manipulated with brutality.
+ Go up and down always in front oh the platform.
+ Be sure to wear shoes with a secure support
+ Do not go up the platform if you are subject to dizziness or fatigue.
+ Ne pas utiliser sans la mise en place des stabilisateurs.
+ Do not use without stabilizer in place
+ Once on the plateform, be sure to lock the barrier
4. Entretien
+ Check the general condition of the platform before each use (state of the parts and their geometry, if
parts have to be replaced, use only TUBESCA-COMABI components, see manufacturer's service sheet
http://tubesca-comabi.com/documentation/documentation-technique/ ).
+ After each construction site, be sure to clean the platform with a clean cloth.
+ This platform must be periodically controlled and the results of these checks, recorded.
61029_250_ind_04 du 07/2021
Grab the red buttons.
http://www.tubesca-comabi.com
Lift the barrier and
access to platform.
Lower the barrier and
ensure the good
positioning in the
receiver.
Page 4
Publicité
