Honeywell HF Serie Mode D'emploi page 18

TROUBLESHOOTING GUIDE
The following troubleshooting guide addresses the most common problems. If problems persist, call
customer support. Unplug and disconnect the appliance from the power source before attempting
to troubleshoot.
PROBLEM POSSIBLE CAUSE
No electricity.
The air
Batteries in the remote
conditioning
control need to be
unit does not
replaced.
start
The power cord is not
properly plugged in.
The thermostat
temperature setting
is too close to room
temperature.
Runs a short
Air outlet is blocked.
while only
There are tight bends in
the air hose.
SOLUTION
Check for power.
Change remote control batteries.
Remove and reconnect the power cord.
Lower the set temperature.
Make sure the hose is properly connected.
Connect hose as per instructions on page 4.
EN 14