Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Notes For Use; Connected Wattage - ProfiCare PC-DR 3093 Mode D'emploi

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
5. Unfold the handle (1) until it clicks audibly into place.
NOTE:
The handle can be folded up again for transport (Fig. E).
To do this, press both release buttons (3). The appliance
can be easily lifted using the carrying handle (5).
Overview of the Components /
Scope of Delivery
1 Handle
2 On / off switch ( )
3 Release buttons
4 Steam quantity regulator ( )
5 Carrying handle
6 Operation control light
7 Foot
8 Cleaning cloth with velcro fasteners
9 Carpet attachment
10 Measuring jug
11 Cord wrap
12 Lock for the water tank
13 Water tank
14 Power cable
Not Shown
Fastening screw for the appliance base
Spare cleaning cloth with velcro fasteners

Notes for Use

• The appliance is intended for the thorough cleaning of
floor coverings, such as laminate, marble, ceramic, vinyl,
linoleum, sealed wooden floors, and parquet.
• CAUTION: On surfaces which have been treated with
wax, the wax can be removed using heat and steam.
• Do not use it on unsealed wooden floors. The appliance
must not be left standing on a wooden floor for an ex-
tended period of time under any circumstances. This can
cause the wood to swell.
• Use particular caution when cleaning laminate, vinyl,
linoleum, or other heat-sensitive floors. Too much heat
could cause the glue in the floor to melt or become dis-
coloured. Do a test-cleaning on a non-visible portion first!
• We also recommend that you check the manufacturer's
maintenance instructions for the surfaces to be cleaned
for steam cleaning.
38
PC-DR3093_IM

Connected Wattage

The maximum power consumption of the appliance is
1500 W.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.

Initial Operation

The illustrations can be found on page 4.

Assembling the Appliance Base (Fig. A)

NOTE:
Note the guide rails on the appliance base and the recess
on the appliance.
1. Push the appliance onto the appliance base as far as it
will go.
2. Fasten the appliance base by inserting the screw into the
hole for the foot mount. Now screw the screw in by hand
with a suitable screwdriver until it is tight.

Fastening the Cleaning Cloth (Fig. B)

1. Note the velcro fasteners on the cleaning cloth and on
the appliance base.
2. Fasten the cleaning cloth to the appliance base with the
velcro fasteners.

Unfastening the Cleaning Cloth

WARNING: Risk of injury!
Wait until the appliance has cooled down before removing
the cleaning cloth.
• Simply pull the cleaning cloth off of the appliance base.

Fill in Water (Fig. D)

NOTE:
• Use only distilled water.
• The maximum filling capacity is 450 ml. Use the meas-
uring jug provided.
• You can also remove the water tank from the appliance
in order to fill it.
CAUTION:
Battery water, water from the dryer, or water containing
additives, such as cleaning agents, alcohol, fabric
softener, or other chemicals must not be poured into the
water tank. This may result in damage to the appliance.
19.01.21