Hornbach FQ-ARM 4047 BASIC Mode D'emploi page 103

CUTTING HEIGHT
1
Pull out the height adjustment
lever 7 and the desired cutting
depth.
Warning! Make sure the ma-
chine is switched off and the
battery is removed.
SAFETY PLUG
1
Insert the safety plug directly be-
fore starting and remove it when
interrupting or terminating the
work.
COLLECTION BAG
1
Lift the back flap 13 and attach
the collection bag 5 to the mower.
Warning! Wait until the blade
has come to a complete stop
before opening the safety flap.
MULCHING
1
Remove the collection bag 5 and
attach the mulching key securely.
Then lower the back flap 13.
Warning! Wait until the blade
has come to a complete stop
before opening the flaps.
REPLACING THE BLADE
1
Loosen the fastening screw A
and remove the worn blade.
Warning! Switch off and re-
move the battery first. Al-
ways use protective gloves.
BATTERIES
2
Lift the battery cover 12 and push
the battery (not included) in until
it clicks into place.
CONTROLS
2
In order to switch the machine
on, press and hold the safety
button 3, tilt the machine back-
wards, pull the on/off trigger 2
and release the safety button 3.
2
If the collection bag 5 is securely
attached to the mower, lower the
back flap 13.
2
Lift the side flap 8 and hook the
side unloader securely on the bar
beneath the side flap. Then lower
the side flap 8.
2
Observe the rotation direction
when replacing the blade.
Tighten the fastening screw A.
Danger! The blade should
only be replaced by author-
ized persons.
EN
103