Troubleshooting - Hornbach FQ-ARM 4047 BASIC Mode D'emploi

Troubleshooting

Warning! Make sure the machine is switched off and the battery is
removed. Always wear protective gloves.
Problem Possible cause
Motor does Battery empty
not run
Unsuitable cutting areas
Blade is blocked
Safety plug is not con-
nected
Battery is not correctly
inserted
Wrong cutting height
Motor power Wrong cutting height
drops
Discharge chute is
blocked
Poor and uneven cut
Collection bag Unsuitable cutting areas
is not filled
suitably
Poor and uneven cut
Collection bag is full
Discharge chute is
blocked
Solution
Recharge battery
Start on short or already mown
grass.
Clean discharge chute and hous-
ing (blade must rotate freely)
Connect safety plug
Remove battery and insert again
Set the wheels to the correct
cutting height
Set the wheels to the correct
cutting height
Clean discharge chute and hous-
ing (blade must rotate freely)
Replace the blade (contact ser-
vice centre)
Set the wheels to the correct
cutting height
Allow lawn to dry
Replace the blade (contact ser-
vice centre)
Empty the collection bag
Clean discharge chute and hous-
ing (blade must rotate freely)
EN
105