Service; Specific Safety Rules; Operation And Maintenance; Getting Started - ENAR SPYDER MB32 Manuel D'instructions

DO NOT USE tool if switch does not turn it on or off.
DISCONNECT the plug from the power source before making any adjustments, changing accessories, or
storing the tool.
STORE idle tools out of reach of children and other untrained persons.
MAINTAIN tool with care. KEEP cutting tools sharp and clean.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that may
affect the tools operation. If damaged, have the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.

3.5 SERVICE

Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

3.6 SPECIFIC SAFETY RULES

For the proper operation of the converter, MAKE SURE that operators have been instructed in the proper
management of this machine.
The converter SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
Before connecting the converter to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment plate, located in the top part.
ENSURE that all frame screws are tight before starting work.
The motor plug should not be used to start or stop the equipment.
The electrical feeding cable should not be used to remove the plug from the socket.
AVOID the flattening of the cable by heavy machinery which could cause breakage.
Be sure that the parts of the poker are tight before starting work.
Keep the converter clean and dry.
Make sure that the electrical cable is with the proper section and functioning properly.
Before doing any work of maintenance, disconnect the motor from the electrical system.
When connecting to a generator, make sure that the out tension and frequency is stable , right and has the
proper power.
(the converter feeding voltage should not vary than +/- 5% as stated on the converter plate.
The level of acoustic pressure is less than 70 dB. Proper protective equipment should be used.
The vibration that transmits to the operator does not exceed 2,5m/2 of acceleration.
The vibrating pokers should not be working out of concrete more than 2 minutes.
Be sure that the parts of the poker are tight before starting work.
When finishing the job or when taking a break, the operator should switch off, disconnect it from the
electrical system, place it in such a way that should not fall or tip.
IN ADDITION, LOCAL COUNTRY STABLISHED ORDINANCES SHOULD BE RESPECTED.
4

OPERATION AND MAINTENANCE

4.1 GETTING STARTED

Read item 3 USAGE CONDITIONS

4.2 VIBRATING POKER CONNECTION TO THE CONVERTERS

The converter has a socket to connect the vibrating pokers. Be sure poker nut is tight.
FRECUENCY CONVERTER AND POKERS
AUTEK MAQUINARIA 5392 7077
AUTEK MAQUINARIA 5392 7077
MB32, MB52, MB62, MB72, MB31, MB51, MB61
en
SPYDER
5