Charger And Ac Power Cord Connections; Installation Instructions; Features; Charging The Internal Battery Of The Memory Saver - Schumacher Electric DSR136 Manuel D'utilisation

3. CHARGER AND AC POWER CORD CONNECTIONS

WARNING!
RISK OF ELECTRIC SHOCK OR FIRE.
3.1 The memory saver's charger is for use
on a nominal 120-volt circuit. The plug
must be plugged into an outlet that
is properly installed and grounded in
accordance with all local codes and

4. INSTALLATION INSTRUCTIONS

4.1 Remove all cord wraps and uncoil the cables prior to using the memory saver.

5. FEATURES

1

6. CHARGING THE INTERNAL BATTERY OF THE MEMORY SAVER

IMPORTANT:
CHARGE IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS TO KEEP
THE MEMORY SAVER'S INTERNAL
BATTERY FULLY CHARGED.

6.1 LED Indicators:

To check the internal battery's charge
status, press the Battery Status button on
the front of the memory saver.
The LEDs will indicate the charge level as
follows:
• A red LED indicates a 50% or less
charge and you should immediately
recharge the memory saver.
• A yellow LED indicates a 50 to 75%
charge. The memory saver may be used
but should be recharged as soon as
possible.
2 3
4
ordinances. The plug pins must fit the
receptacle (outlet). Do not use with an
ungrounded system. NOTE: Pursuant to
Canadian Regulations, use of an adapter
plug is not allowed in Canada. Use of an
adapter plug in the United States is not
recommended and should not be used.
1. Internal battery charger plug
2. Charging status LEDs
5
3. Internal battery status LEDs
4. Internal battery status test
5. OBDII (On-Board Diagnostic)
6. Plug adaptors (types A and I)
7. Memory saver detector ON/
8. Memory saver 5A ATC fuse
9. 12V DC power outlet (on back)
10. Velcro strap
• A green
battery is fully charged.
• The CHARGING
the memory saver is charging (connected
to an AC power source.) At full charge,
the CHARGED
6.2 Charging the Internal Battery Using the
Included Wall Charger
1. Work in a well ventilated area and do
not restrict the ventilation in any way.
2. Use only the included wall charger to
charge the internal battery. Using any
other charger or using the included
charger for any other purpose could
result in personal injury or property
damage.
3. Use the appropriate plug adaptor for
your plug type (type A for USA or type I
for AUS).
• 6 •
switch
connector with memory saver
detector
Not shown:
OFF switch (on back)
(on back)
LED indicates the internal
(red) LED indicates
(green) LED will light.