SPIDER BD-00010 ONLY Mode D'emploi page 3

• Allow adequate fall clearance below the work surface when using this
device.
• Never work above the device, unless mounted for use within a structure
(e.g. lifts, in accordance with installation instructions).
• Never use the device as a restraint or positioning device.
• Never allow the lanyard or lifeline to become slack or to pass under or
entwine around the user's arms, legs, or any other obstacle.
• Do not allow webbing to come in contact with high temperature surfaces,
welding, heat source, electrical hazards, or moving machinery.
• Do not tie knots in lanyard or lifeline, or wrap around sharp, rough edges,
or small diameter structural members.
• Use in highly corrosive or caustic environment dictates a more frequent
inspection and servicing program to ensure the integrity of the device is
maintained. Consult Spider if in doubt of chemical effect.
• Employers must provide for prompt rescue in the event of a fall.
• This product is designed for personal fall protection. Never use fall
protection equipment for purposes other than which it is designed.
B. SYSTEM COMPATIBILITY
Spider self-retracting lanyards and lifelines are designed for use with Spider

approved components. Substitution or replacement with non-approved
components could endanger the compatibility within the system and may
affect the reliability and safety of the total system. Substitution or replacement
must be accomplished only under the supervision of a qualified person. It is
recommended that the worker wear a Spider full-body harness to distribute the
fall arresting forces over the body and to keep an unconscious or injured worker
in an upright position.
Proper use of fall arrest systems can save lives and reduce the potential of
serious injuries from a fall. The user must be aware that forces experienced
during the arrest of a fall or prolonged suspension may cause bodily injury.
Consult a physician if there is any question about the user's ability to use this
product.
*
II. INSTALLATION OF SELF-RETRACTING LANYARDS
MODEL BD-00010 ONLY
Note: Anchorage connector (Carabiner) attach directly to
housing on this model.
TYPICAL INSTALLATION
The Spider self-retracting lanyard, Model BD-00010, must be mounted to an
anchorage capable of supporting a 5,000 pound (22 kN) tensile load, or the
anchorage must be designed, installed, and used under the supervision of a
qualified person as part of a complete fall arrest system which maintains a safety
factor of two. The self-retracting lanyard must be used in one of the following
arrangements:
1. Mounted to an overhead anchor by the swivel attachment using a locking
carabiner (see Fig. 1) or
3