Display Unit Installation; Battery Installation; Signal Strength Test - Generac 006664-0 Mode D'emploi

Installation
Final Installation - All Years
1. Reconnect the positive (+) red battery cable first. Then, reconnect the negative (-) black cable.
2. Install the controller and cover. Secure with fasteners (2008 Home Standby Units only).
3. Reinstall the generator front access panel.
4. Install the 7.5 Amp control panel fuse.
5. Reinstall the T1 fuse into the transfer switch.
6. If applicable, turn ON the home's electrical panel main breaker.
7. Place the generator in the AUTO mode.
8. Use install wizard to set the date, time and exercise function.

DISPLAY UNIT INSTALLATION

BATTERY INSTALLATION

The Wireless Local Monitor display unit is powered by two non-rechargeable AAA alkaline batteries
that are installed by removing the battery cover on the back of the unit. Observe correct battery
polarity which is indicated near the battery compartment. The expected battery life under normal
use is six months when using standard AAA 1.5V, 1.2Ah alkaline batteries.
Batteries should be changed when the low battery indicator warning is activated.
The Wireless Local Monitor does not have a power switch. The monitor automatically powers up
when the batteries are inserted.

SIGNAL STRENGTH TEST

The display unit is equipped with a Signal Strength Test Mode. Press the Test button for five (5)
seconds to enter the Signal Strength Test Mode. The Green, Yellow and Red lights will alternately
light for a short period to indicate transition from Status mode to the Signal Strength Test Mode. The
unit will be in this mode for 30 seconds. During the Signal Strength Test:
• Green - Good Signal Strength
• Yellow - Marginal Signal Strength
• Red - No Signal Strength
After 30 seconds, the unit will automatically exit the Signal Strength Test Mode. When this happens,
the indicators alternately light to signal the transition back to Status Mode.
Extended or frequent use of the Signal Strength Test may deplete battery life.
The display unit will still work if the signal strength is yellow but battery life may be
reduced.
10
NOTE:
NOTE:
NOTE: